Woodward 2301E, Инструкция по установке и эксплуатации, Страница: 120 / 182

2301E Digital Control Manual 26641
110 Woodward
02 FORCE OUTPUT STATUS (monitor)
Displays the test status.
03 TURN ON DO1 dflt = FALSE (TRUE, FALSE)
Tune to TRUE to turn the driver output #1 on.
04 DISCRETE OUTPUT #1 (monitor)
Displays the output status of output #1.
05 TURN ON DO2 dflt = FALSE (TRUE, FALSE)
Tune to TRUE to turn the driver output #2 on.
06 DISCRETE OUTPUT #2 (monitor)
Displays the output status of output #2.
07 TURN ON DO3
dflt = FALSE (TRUE, FALSE)
Tune to TRUE to turn the driver output #3 on.
08 DISCRETE OUTPUT #3 (monitor)
Displays the output status of output #3.
09 TURN ON DO4 dflt = FALSE (TRUE, FALSE)
Tune to TRUE to turn the driver output #4 on.
10 DISCRETE OUTPUT #4 (monitor)
Displays the output status of output #4
11 TURN ON CB AUX RELAY dflt = FALSE (TRUE, FALSE)
Tune to TRUE to energize the internal load sharing relay, observe the green LED
next to terminals 9 and 10.
12 LOAD SHARE RELAY (monitor)
Displays the status of the load share relay.
13 ADJUST ANALOG OUTPUT (%) dflt = 0.000 (0.00
–100.00)
Adjust 0 to 100 for analog output at 16 and 17 to change from 0 to 20 mA.
14 ANALOG OUT (%) (monitor)
Displays the status of the analog output.
15 ADJUST ACTUATOR OUTPUT (%) dflt = 0.000 (0.00
–100.00)
Adjust 0 to 100 for actuator output at 13 and 14 to change from 0 to 200 mA.
16 ACTUATOR OUTPUT (mA) (monitor)
Displays the status of the actuator output.
T**KW INPUT CALIBRATION**
This section calibrates the 2301E internal load sensor to correspond its output to
measured kilowatts. This calibration allows the control to calculate the 100% load
gain voltage, droop %, and load sharing ratio. For proper calibration the
generator load should be as close as possible to required generator voltage and
unity power factor.
01 ENTER RATED LOAD (KW) dflt = 500.000 (10.00
–30000.0)
Adjust this value for the rated load of the generator.