Woodward 2301E, Инструкция по установке и эксплуатации, Страница: 112 / 182

2301E Digital Control Manual 26641
102 Woodward
02 PRESSURE X1 dflt = 6.000 (
–1000.00–1000.00)
This sets the pressure at the first breakpoint. The limit on fuel demand below this
point is extrapolated from this point and the pressure X2
below.
03 MAP LIMIT Y1 dflt = 100.000 (0.00
–100.00)
This sets the maximum fuel demand at the first pressure setpoint.
04 PRESSURE X2 dflt = 8.000 (
–1000.00–1000.00)
This sets the pressure at the second breakpoint.
05 MAP LIMIT Y2 dflt = 100.000 (0.00
–100.00)
This sets the maximum fuel demand at the second pressure setpoint.
06 PRESSURE X3 dflt = 10.000 (
–1000.00–1000.00)
This sets the pressure at the third breakpoint.
07 MAP LIMIT Y3 dflt = 100.000 (0.00
–100.00)
This sets the maximum fuel demand at the third pressure setpoint.
08 PRESSURE X4 dflt = 15.000 (
–1000.00–1000.00)
This sets the pressure at the fourth breakpoint.
09 MAP LIMIT Y4 dflt = 100.000 (0.00
–100.00)
This sets the maximum fuel demand at the fourth pressure setpoint.
10 PRESSURE X5 dflt = 20.000 (
–1000.00–1000.00)
This sets the pressure at the maximum breakpoint.
11 MAP LIMIT Y5
dflt = 100.000 (0.00
–100.00)
This sets the maximum fuel demand at the maximum pressure setpoint.
12 MAP NEAR FUEL LIMIT % dflt = 5.000 (0.00
–10.00)
When the maximum air pressure limit comes within the range of this setting the
overload contact is initiated.
13 MAP DELAY TIME CONTACT dflt = 0.500 ( 0.00
–30.00)
When the maximum air pressure limit is within the near fuel limit range for longer
than this delay time an overload contact is activated.
14 MAP OVERLOAD PULS TIME dflt = 0.500 (0.00
–100.00)
This is the time for the overload contact to be active. In Configure Menu
D**Discrete Out Options** a discrete output can be setup at parameter 8
(Overload Contact).