Woodward 2301E, Инструкция по установке и эксплуатации, Страница: 10 / 182

2301E Digital Control Manual 26641
viii Woodward
Lloyd’s Register
LR Type Approval Test Specification No. 1, 2002 for
of Shipping: Shipping: Environmental Categories ENV1, ENV2
and ENV3
Nippon Kaiji Kyokai: Requirements specified in Chapter 1, Part 7 of
Guidance for the approval and Type Approval of
materials and equipment for Marine use and
relevant Society’s Rules.
Australia & New Zealand Compliance
These listings are limited to those units bearing the C-Tick mark:
C-Tick (ACA/RSM): Declared Separately to the Australian
Radiocommunications Act of 1992 and the New
Zealand Radiocommunications Act of 1989.
Special Conditions for Safe Use
The control must be installed in a suitable enclosure. The final combination must
be approved by the local authority having jurisdiction.
Connect the ground terminal to earth ground.
Use supply wire rated for minimum 75 °C
Use signal wire rated for a minimum of 240 Vac.
Per EN 60079-15:2010: Device meets ATEX Zone 2 requirements when installed
in an ATEX compliant IP54 or better enclosure.
T3 when the Potential Transformer input is 240 Vac.
T4 when the Potential Transformer input is 120 Vac or less.
EXPLOSION HAZARD
—Do not remove covers or connect/disconnect
electrical connectors unless power has been switched off or the area
is known to be non-hazardous.
Substitution of components may impair suitability for Class I,
Division 2.
RISQUE D’EXPLOSION—Ne pas enlever les couvercles, ni
raccorder / débrancher les prises électriques, sans vous en
assurez auparavant que le système a bien été mis hors
tension; ou que vous vous situez bien dans une zone non
explosive.
La substitution de composants peut rendre ce matériel
inacceptable pour les emplacements de Classe I, Division 2.