Vanderbilt SPCK620, Руководство по установке и настройке

Страница: 185 / 368

Engineer programming via the browser 17
Users
185
Vanderbilt Installation & Configuration Manual A6V10276959
01.05.2016
Attribute Description

SPC4xxx – all users

SPC5xxx – 512

SPC6xxx - 512
Escort The escort feature enforces privileged card holders to
escort other card holders through specific doors. If this
feature is enabled on a door, a card with the “escort” right
has to be presented first, to allow other cardholders without
this right to open the door. The time period in which
cardholders are able to present their cards after a card with
escort right was presented, can be configured per door.
Custodian The custodian feature enforces a card holder with custodian
privilege to always be inside a room (door group) when
other card holders are inside.
The custodian must be the first to enter the room. Only if a
custodian is in the room other cardholders are allowed to
enter. The cardholder with the custodian right will not be
allowed to exit until all non-custodian cards left the room.
Identifies this card holder as a custodian. The user with the
custodian attribute has to be the first who enters a door
group which requires a custodian card holder and has to be
the last that is leaving this door group.
17.8.1.1 Unknown Devices
If an unknown device, such as a fob, PACE, or card, has been scanned but not
assigned to a user, a button is displayed in the relevant section of the users page.

RF- FOB — Unknown Fob button or, if the device is assigned to the user,
Delete FOB button

Pace — Unknown Pace button or, if the device is assigned to the user, Delete
Pace button

Access Control — Unknown card button
To assign a fob, PACE or card to the user:
1. Click the Unknown button for the device. The User page displays the list of
unknown devices.
2. Click Add to assign the device to the user.
Note: To assign a card to the user, the associated user profile must have the
correct site code defined.
To unassign a fob or Pace from a user:
1. Click the Delete button.
The device is unassigned from the user and also deleted from the system.
2. To add the device again, you must rescan it.
To unassign a card from a user:
1. Change the card number to zero (0).
2. Click Save.
The card is unassigned from the user and deleted from the system.
3. To add the card again, you must rescan it.