Vanderbilt SPCK620, Руководство по установке и настройке

Страница: 123 / 368

Engineer programming via the keypad 16
X-BUS
123
Vanderbilt Installation & Configuration Manual A6V10276959
01.05.2016
Keypress Range is 0 – 7 (Max volume)
Voice Annunciation Select speaker volume for chime or disable sound.
Partset Buzzer Range is 0 – 7 (Max volume)
Deactivation
Calendar
Select if the keypad should be limited by calendar. See Calendar.
Mapping gate Select if keypad should be limited by a mapping gate.
Keyswitch Select if keypad should be limited by a keyswitch.
PACE Entry Tick this box to disable the keys on the keypad during the entry time
when a PACE is configured on the keypad.
Areas
Location
Select the secured area where the keypad is located.
Areas Select which areas can be controlled through keypad.
Options
Delay Fullset
Select to configure a delayed set across all keypads. The location of
the keypad is ignored and all areas will perform a full exit time count
down.
NOTICE
An area should be assigned to a keypad only if the keypad is inside the assigned
area, and if an entry/exit route is defined. If an area is assigned, when the
particular area is set or unset then entry and exit timers are used (if configured).
Other features related to entry/exit routes also become available. If no area is
assigned, the area is set or unset immediately and other entry/exit features are
not available.
16.6.4.4 Edit Expanders
To edit expanders:
1. Scroll to EXPANDERS > EDIT.
2. Press SELECT.
3. Scroll to the device to be edited and press SELECT.

Parameters and details, if applicable, are displayed for editing.
4. Press BACK to exit the menu.
For naming and identifying, expanders are allocated zones (in groupings of 8)
with subsequent identities of 1 to 512. (The greatest number in zone identification
is 512.) Therefore, any expander named or identified by a number greater than 63
has no allocated zones.