Vanderbilt SPCK620, Руководство по установке и настройке

Страница: 116 / 368

16 Engineer programming via the keypad
Areas
116
Vanderbilt
Installation & Configuration Manual A6V10276959
01.05.2016
Timer Description Default
General Settings
RF Output Time
RF OUTPUT
The time that the RF output will remain active on the system.
(0 – 999 seconds)
0 sec.
Time Sync Limit
TIME SYNC LIMIT Time limit within which no event will be reported.
(0 – 999 secs) Time synchronization only takes place if
system time and update time are outside this limit.
0 sec.
Link Timeout
LINK TIMEOUT Timeout for Ethernet link fault (0 = Disabled) ( 0 - 250 ) 0 secs
Camera Offline
CAMERA OFFLINE Time for camera to go offline ( 10 - 9999 ) 10 secs
Tech. delay
TECH. DELAY Number of seconds to delay triggering of tech. zones with
tech. delay attribute. (0 – 9999 seconds)
0 sec.
Frequent
FREQUENT This attribute only applies to Remote Maintenance. The
number of hours a zone must open within if the zone is
programmed with the Frequent use attribute. (1 – 9999 hours)
336 hours (2
weeks)
Duress silent Time when duress will remain silent and not restorable from
keypad (0 - 999).
0 Minutes
Holdup/panic silent Number of minutes that a holdup/panic will remain silent and
cannot be restored from the keypad (0 - 999).
0 Minutes
Default times are dependent upon the Engineer configuration. The default times
denoted may or may not be allowable and is dependent on the configuration by
the engineer
16.4 Areas
1. Scroll to AREAS and press SELECT.
2. Scroll to the desired programming option:
ADD For Domestic and Commercial Mode, the area type defaults to Standard.
In Financial Mode, select area type STANDARD, ATM, VAULT or
ADVANCED.
Enter the name of the area and the preferred entry/exit time.
EDIT Edit the following settings:
 DESCRIPTION

ENTRY EXIT
– ENTRY TIMER
– EXIT TIMER
– NO EXIT TIMER
– FOB ENTRY ACTIVE

PARTSET A/B
– ENABLED/DISABLED
– TIMED
– ACCESS TO E/EXIT
– E/EXIT TO ALARM
– LOCAL
– NO BELLS
!