Suzuki GRAND VITARA XL-7, Руководство по обслуживанию

Страница: 49 / 597

3B1-6 POWER STEERING (P / S) SYSTEM
1. P/S fluid
reservoir
F: Forward
1. P / S pulley
2. Mounting bolt
F
REMOVAL
NOTE:
Be sure to clean each joint of suction and discharge sides
thoroughly before removal.
1) Remove suction hose from pump, then disconnect battery nega-
tive cable.
2) Remove P / S fluid reservoir with suction hose.
3) Remove union bolt. Then disconnect high pressure pipe from
pump.
NOTE:
As fluid flows out of disconnected joints, put a receptacle
under joints or a plug to pipe.
4) Loosen related bolts and remove power steering drive belt.
5) Remove P / S pump mounting bolt (s).
6) Remove P / S pump.
NOTE:
Plug each port of removed pump to prevent dust or any oth-
er foreign matter from entering.
DISASSEMBLY AND ASSEMBLY
For the disassembly and assembly procedures of P / S pump, refer
to the same section of the service manual mentioned in FORE-
WORD of this manual, excluding the description of pressure switch
(terminal set).
INSTALLATION
Reverse removal procedure, and then noting the following instruc-
tions.
D
For tightening torques, refer to structural diagram on previous
page.
D
Adjust power steering pump drive belt by referring to “INSTALLA-
TION of GENERATOR BELT” in Section 6H.
D
Fill specified power steering fluid after installation and bleed air
without failure.