Suzuki GRAND VITARA XL-7, Руководство по обслуживанию

Страница: 466 / 597

AUTOMATIC TRANSMISSION (4 A / T) 7B1-61
[A]: Shift the select lever
with its button pushed in.
[B]: Shift the select lever
without pushing its button.
1. Dipstick
2. Dipstick without COLD leverl indicator
3. Dipstick with COLD level indicator
FULL HOT
FULL HOT
LOW HOT
LOW HOT
or
ON-VEHICLE SERVICE
MAINTENANCE SERVICE
FLUID LEVEL
LEVEL CHECK AT NORMAL OPERATING TEMPERATURE
1) Stop vehicle and place it level.
2) Apply parking brake and place chocks against wheels.
3) With selector at P position, start engine.
4) Warm up engine till fluid temperature reaches normal operating
temperature (70 – 80
_
C (158 – 176
_
F)). As a guide to check fluid
temperature, warm up engine till engine coolant temperature
meter indicated around 1 unit above “C” point.
5) Keep engine idling and shift selector slowly to “L” and back to “P”
position.
6) With engine idling, pull out dipstick (1), wipe it off with a clean
cloth and put it back into place.
7) Pull out dipstick (1) again and check fluid level indicated on it.
Fluid level should be between FULL HOT and LOW HOT. If it is
below LOW HOT, add an equivalent of DEXRON

-III up to FULL
HOT.
Fluid specification:
An equivalent of DEXRON

-III
NOTE:
D
DO NOT RACE ENGINE while checking fluid level, even af-
ter the engine start.
D
DO NOT OVERFILL. Overfilling can causes foaming and
loss of fluid through breather. Then slippage and trans-
mission failure can result.
D
Bringing the level from LOW HOT to FULL HOT requires
0.3 liters (0.64 / 0.53 US / Imp.pt).
D
If vehicle was driven under high load such as pulling a
trailer, fluid level should be checked about half an hour af-
ter it is stopped.