Suzuki GRAND VITARA XL-7, Руководство по обслуживанию

Страница: 189 / 597

1. Camshaft position sensor
2. ECM
6-1-50 ENGINE DIAGNOSIS (RHZ ENGINE WITH TRIPLE-CONNECTOR ECM)
DTC P0340 (P0335/P0340) CAMSHAFT POSITION SENSOR CIRCUIT MALFUNCTION
WIRING DIAGRAM
DTC CONFIRMATION PROCEDURE
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool.
3) Crank engine for 3 seconds or more and keep it at idle for 1 min. if engine start.
4) Check DTC and pending DTC by using scan tool.
TROUBLESHOOTING
STEP ACTION YES NO
1 Was “ENGINE DIAG. FLOW TABLE” performed? Go to Step 2. Go to “ENGINE DIAG.
FLOW TABLE”.
2 Check Sensor Power Supply Circuit
1) Connect scan tool to DLC with ignition switch
OFF and then turn ignition switch ON.
2) Dose scan tool indicate DTC as shown below?
<Using Suzuki mode of Suzuki Scan tool>
P1614
<Using Generic Scan tool or Euro mode of Suzuki
Scan tool>
P0560
Go to DTC P1614
(P0560) Diag. Flow
Table. Go to Step 3.
3 Is engine cranked? Go to Step 4. Go to “CRANKING
SYSTEM” section.
4 Is engine started? Go to Step 5. Check CKP sensor
(Engine speed
sensor) and its circuit
according to DTC
P0335 (P0335) Diag.
Flow Table.
5 Check CMP Sensor and connector for proper
installation.
Is CMP sensor installed properly and connector
connected securely? Go to Step. 6. Correct.