Suzuki GRAND VITARA XL-7, Руководство по обслуживанию

Страница: 121 / 597

1. Double relay
2. ECM
3. EGR throttle solenoid valve
4. Fuel pump
5. “ENG” fuse (15 A)
6. “FUEL PUMP” fuse (15 A)
ENGINE DIAGNOSIS (RHZ ENGINE WITH SINGLE-CONNECTOR ECM) 6-61
DTC P1402 (P0510) THROTTLE SOLENOID VALVE CIRCUIT MALFUNCTION
WIRING DIAGRAM
DTC CONFIRMATION PROCEDURE
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ON ignition switch and clear DTC, pending DTC and freeze flame data by using scan tool.
3) Turn off ignition switch and then on.
4) Check DTC and pending DTC by using scan tool.
TROUBLESHOOTING
STEP ACTION YES NO
1 Was “ENGINE DIAG. FLOW TABLE” performed? Go to Step 2. Go to “ENGINE DIAG.
FLOW TABLE”.
2 Is operating sound heard from fuel pump? Go to Step 3. Proceed to DTC
P0230 Diag. Flow
table.
3 Check Wire Harness
1) Disconnect EGR throttle solenoid valve
connector with ignition switch turned OFF.
2) With ignition switch ON, check voltage between
“BLU / WHT” wire terminal of solenoid valve
connector and ground.
D
Within 5 sec. after ignition switch ON: 10 – 14 V
D
Over 5 sec. after ignition switch ON: about 0 V
Is check result as specified?
Go to Step 4. “BLU / WHT” wire
open, shorted to
power / ground or fuse
broken.
4 Check EGR Throttle Solenoid Valve
1) Check solenoid valve referring to Section 6E3.
Is it in good condition?
D
“PPL / BLK” wire
open or shorted to
power / ground
D
Poor C51-55
connection
If wire and connection
are OK, substitute a
known-good ECM and
recheck.
Faulty EGR solenoid
valve.