Raymarine LIGHTHOUSE 4, Руководство по эксплуатации

Страница: 334 / 504

• Generator line 1 to neutral voltage (PGN 127747)
• Generator line 1 to line 2 voltage (PGN 127747)
• Generator line 1 frequency (PGN 127747)
• Generator line 2 power (PGN 127745)
• Generator line 2 current (PGN 127745)
• Generator line 2 to neutral voltage (PGN 127748)
• Generator line 2 to line 3 voltage (PGN 127748)
• Generator line 2 frequency (PGN 127748)
• Generator line 3 power (PGN 127746)
• Generator line 3 current (PGN 127746)
• Generator line 3 to neutral voltage (PGN 127749)
• Generator line 3 to line 1 voltage (PGN 127749)
• Generator line 3 frequency (PGN 127749)
The additional data items above will be available for each detected 3 phase
generator.
Load cell data
Load cells are sensors used to measure the load bearings on key rigging
components, such as forestay, sidestay, backstay, or any sheet, halyard,
control line, vang, tack line, or runner.
A predefined list of [Load cells] is available.
For load cell data to be populated a supported load cell gateway is required.
Cyclops Marine load cells
Cyclops Marine is a third party company providing wireless load-sensing
devices for use in sailing, and especially race sailing.
The Cyclops Marine sensors connect wirelessly to the below-deck Cyclops
Marine Gateway, which interfaces with compatible Raymarine MFDs and
displays key load bearings at identified stress points on a yacht's rigging.
In the MFD's Dashboard app, you can see at a glance the live, static and
dynamic load data transmitted by the Cyclops Marine sensors, at up to 50
sensor placements.
22.4 Engine page
The engine page is always available. The number of engines displayed on
the engine page is based on the number of engines selected during the initial
MFD start up wizard. The engine page includes data relevant to engines and
includes the graphical engine dial.
Example single engine data page
1. BATTERY 1 — Engine battery voltage.
2. OIL TEMP — Engine oil temperature.
3. GEAR — Transmission gear.
4. RPM indicator — Graphical representation of engine RPM.
5. Oil pressure indicator — Current engine oil pressure indication.
6. RPM — Digital RPM value.
7. Maintenance indicator — Illuminates when engine maintenance is
required.
8. Rudder bar — Provides an indication of rudder position.
9. Coolant temperature — Current engine coolant temperature indication.
10. Check engine — Illuminates when an engine fault is detected.
11. SOG — Speed Over Ground.
12. FUEL — Graphical representation of the percentage of fuel remaining.
334