Chapter 8: Using the Command Line Interface
323
Actuator Information
This command syntax shows an actuator's information.
#
show actuators <n>
To show detailed information, add the parameter "details" to the end of
the command.
#
show actuators <n>
details
Variables:
<n> is one of the options:
all
, or a number.
Option
Description
all
Displays the information for all actuators.
Tip: You can also type the command without
adding this option "all" to get the same data.
A specific
actuator
number*
Displays the information for the specified actuator
only.
* The actuator number is the ID number assigned to the actuator. The ID
number can be found using the EMX web interface or CLI. It is an integer
starting at 1.
Displayed information:
Without the parameter "details," only the actuator ID, type and state
are displayed.
With the parameter "details," more information is displayed in
addition to the ID number and actuator state, such as the serial
number and X, Y, and Z coordinates.
Содержание EMX2-888
