KENR6932
65
Disassembly and Assembly Section
3.
Tighten bolts (7) to a torque of 22 N·m (16 lb ft) in
sequence that is shown in Illustration 112. Tighten
remaining bolts that secure oil
fi
lter base to a
torque of 22 N·m (16 lb ft).
4.
Remove plugs from tube assembly (6). Remove
caps for the fuel return from cylinder head and
from transfer pump (5). Install tube assembly (6)
to cylinder head and to transfer pump (5).
5.
Follow Steps 5.a through 5.e in order to connect
engine wiring harness (4).
a.
Place the harness in position.
b.
Connect engine wiring harness (3) to position
sensor (1) for the fuel injection pump.
c.
Connect engine wiring harness (3) to oil
pressure sensor (8).
d.
Reconnect wiring harness (3) to the solenoid
for the fuel injection pump.
e.
Install new cable straps in order to secure
engine wiring harness (3) to assembly of oil
cooler (4).
6.
Remove plugs from all plastic tube assemblies
(2). Remove caps from appropriate ports. Install
plastic tube assemblies (2).
7.
Fill the cooling system to the correct level.
Refer to Operation and Maintenance Manual,
“Cooling System Coolant - Change” for the correct
procedure.
8.
Check level of engine lubricating oil. Refer to
Operation and Maintenance Manual, “Engine Oil
Level - Check” for the correct procedure.
End By:
a.
Install the bracket for the Electronic Control
Module. Refer to Disassembly and Assembly,
“ECM Bracket - Remove”.
i02654488
Engine Oil Relief Valve -
Remove and Install
Removal Procedure
Start By:
a.
Remove the engine oil pan. Refer to Disassembly
and Assembly, “Engine Oil Pan - Remove”.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Personal injury can result from being struck by
parts propelled by a released spring force.
Make sure to wear all necessary protective equip-
ment.
Follow the recommended procedure and use all
recommended tooling to release the spring force.
g01336497
Illustration 113
1.
Use an allen wrench to loosen cap (1). Carefully
remove cap (1) from the housing of engine oil
pump (4).
Note:
The spring force will be released when the cap
is removed.
2.
Remove spring (2) from the bore for the relief
valve in the housing of engine oil pump (4).
3.
Use long nose pliers to remove plunger (3) from
the bore for the relief valve in the housing of
engine oil pump (4).