KENR6932
179
Disassembly and Assembly Section
g01342046
Illustration 361
3.
Remove bolts (9) from fuel manifold (10).
4.
Loosen bolts (11) that secure mounting bracket
(8) to the inlet manifold.
g01342051
Illustration 362
5.
Remove bolts (12) that secure mounting bracket
(8) to the cylinder block.
6.
Slide mounting bracket (8) horizontally away from
the cylinder block in order to remove the mounting
bracket.
Note:
Avoid placing any strain on the fuel injection
lines when the fuel manifold is not supported by the
mounting bracket.
Installation Procedure
1.
Ensure that the mounting bracket for the electronic
control module is clean and free from damage.
If the mounting bracket is damaged, replace the
bracket.
g01342051
Illustration 363
g01342046
Illustration 364
2.
Position mounting bracket (8) against the cylinder
block. Ensure that the two slots in the top face of
the mounting bracket are aligned with bolts (11).
Slide the mounting bracket into position against
the cylinder block.
3.
Install bolts (12)
fi
nger tight.
4.
Install bolts (9) that secure fuel manifold (10) to
mounting bracket (8)
fi
nger tight.
Note:
Ensure that the fuel manifold is seated against
the mounting bracket before bolts (9) are tightened.
Ensure that the fuel injection lines are not stressed
when the bolts are tightened.
5.
Tighten bolts (11) to a torque of 22 N·m (16 lb ft).
6.
Tighten bolts (12) to a torque of 22 N·m (16 lb ft).
Tighten bolts (9) to a torque of 22 N·m (16 lb ft).