112
KENR6932
Disassembly and Assembly Section
g01342431
Illustration 217
5.
Tighten the bolts in the numerical sequence that
is shown in Illustration 217. Tighten the bolts to a
torque of 9 N·m (79 lb in).
6.
Connect the breather hose to the separator for
the crankcase breather. Refer to Disassembly and
Assembly, “Crankcase Breather - Install”.
7.
If the engine is equipped with a cover over the fuel
system this will need to be Installed.
i02697661
Valve Mechanism Cover Base -
Remove and Install
(Composite Valve Mechanism
Cover Base)
Removal Procedure
Table 50
Required Tools
Tool
Part
Number
Part Description
Qty
A
-
Circlip Pliers
1
Start By:
a.
Remove the valve mechanism cover. Refer to
Disassembly and Assembly, “Valve Mechanism
Cover - Remove and Install”.
b.
Remove the fuel injection lines. Refer to
Disassembly and Assembly, “Fuel Injection Lines
- Remove”.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Use a deep socket in order to remove the electrical
connections from the electronic unit injectors. Use of
incorrect tooling will result in damage to the electronic
unit injectors.
g01355167
Illustration 218
Typical example
1.
Make a temporary identi
fi
cation mark on
connections (1).
2.
Use a deep socket to remove connections (1)
from electronic unit injectors (2).
3.
Disconnect plugs (7) from harness assemblies (4).
4.
If necessary, follow Steps 4.a through 4.e in order
to remove harness assemblies (4) from valve
mechanism cover base (6).
a.
Cut cable strap (3).
b.
Use Tooling (A) to remove circlip (5).
c.
From the outside of valve mechanism cover
base (6), push harness assembly (4) inward.
Withdraw the harness assembly from valve
mechanism cover base (6).
d.
Remove O-ring seal (8) from harness assembly
(4).