34
KENR6932
Disassembly and Assembly Section
10.
Use Tooling (B) to tighten torx screw (12) to a
torque of 27 N·m (20 lb ft).
11.
Use Tooling (E) to tighten the fuel injection line to
a torque of 30 N·m (22 lb ft). Refer to Disassembly
and Assembly, “Fuel Injecton Lines - Install”.
12.
Repeat Steps 2 through 11 in order to install the
remaining electronic unit injectors.
13.
Use a deep socket to install harness assemblies
(9) to electronic unit injectors (11). Use Tooling (F)
to tighten connections (10) to a torque of 2.4 N·m
(21 lb in).
g01355048
Illustration 60
The electronic unit injector is not shown for clarity.
NOTICE
Failure to ensure that ALL valve bridges are correct-
ly seated onto the valve stems will cause interference
between the pistons and the valves, resulting in dam-
age to the engine.
14.
Install the rocker shaft assembly. Refer to
Disassembly and Assembly, “Rocker Shaft -
Install”.
g01247489
Illustration 61
Typical example
15.
Tighten banjo bolt (7) for tube assembly (6).
Tighten the banjo bolt to a torque of 21 N·m
(15 lb ft).
16.
Restore the fuel supply to the engine.
17.
Restore the electrical supply to the engine.
18.
Remove the air from the fuel system. Refer to
Operation and Maintenance Manual, “Fuel System
- Prime” for more information.
i02654357
Turbocharger - Remove
(Turbocharger Top Mounted )
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that
fl
uids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the
fl
uid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing
fl
uids.
Dispose of all
fl
uids according to local regulations and
mandates.
Note:
Plug and cap all open ports and tube
assemblies.