Motortech MIC-Marine, Руководство по эксплуатации

Страница: 99 / 176

8 Settings via the MICT
Rev. 09/2019 99
– Index/Reset Position
Enter the distance between the first event after the set index/ reset marking and top dead
center. With the button
Adjust , you can enter the measured firing angle for a given nominal
value. The system calculates the difference from these values, which is added to or
subtracted from the index/reset position.
If you are using two redundant pickup sets, enter the value for pickup set 1 here. The
corresponding value for pickup set 2 is determined by the ignition controller. Details can be
found in the information box
Setting up a redundant pickup system.
– Enable Redundancy
Activate the checkbox to be able to define two redundant pickup sets in the view Engine –
Pickups – Inputs . For general information on this, read the section Redundant Pickup System
on page 60.
– Aux. Pickup Supply Voltage
Enter the supply voltage with which the active pickup is to be operated. A value between 5 V
and 24 V is possible. The set auxiliary supply voltage is independently made available on
the inputs
Pickup 1 Power to Pickup 3 Power and on the inputs Pickup 4 Power to Pickup 6
Power . If two redundant pickup sets are configured correspondingly, failure of the auxiliary
supply voltage affects just one pickup set.
Setting up a redundant pickup system
The index/reset position can be only configured for pickup set 1. For the
pickup set 2, the index/reset position is determined automatically the first
time the engine is started after the ignition controller has been configured.
The following procedure must be ensured:
1. Download the configuration to the ignition controller.
2. Start the engine.
▸ The ignition controller synchronizes both pickup sets.
▸ In the window Runtime Data – Overview , the status display
Available in the area Pickup Redundancy is illuminated green if the
synchronization has been successfully completed.
▸ The index/reset position for the pickup set 2 is now determined and
stored automatically.
The saved position is cleared when a configuration is downloaded to the
device again. The index/reset position for the pickup set 2 cannot be
configured manually.