Motortech MIC-Marine, Руководство по эксплуатации

Страница: 133 / 176

8 Settings via the MICT
Rev. 09/2019 133
8.12.6.1 Information
Information Description
Access control disabled. The Access control was disabled (see Access Control for
MIC6 on page 82).
Access control enabled. The Access control was enabled (see Access Control for
MIC6 on page 82).
All access control PINs reset. All PINs for access control were reset (see Access Control
for MIC6 on page 82).
CAN interface CAN number entered
bus off state.
The CAN interface CAN number has entered Bus off state
(see Runtime Data – Diagnostics on page 141).
CAN interface CAN number left bus
off state.
The CAN interface CAN number has left the Bus off state
(see Runtime Data – Diagnostics on page 141).
CAN reset requested by
GPI
number .
A CAN reset was requested via general purpose input
GPI
number (see Inputs/Outputs – Inputs on page 112).
CANopen on interface CAN number
changed state to " name ".
The CANopen at interface CAN number has changed state
to " name " (state of NMT State Machine according to CiA
DS 301).
Configuration changed. The Configuration of device was changed (via the MICT or
via fieldbus).
Date and time set. The date and the time have been set.
Device (firmware
number.number.number.number )
started at a supply voltage of x V .
The device (firmware number.number.number.number )
was started with a supply voltage of x V .
Device reset requested by
GPI
number failed because pickup
signals have been detected.
The device reset requested by GPI number failed because
pickup signals have been detected (see Inputs/Outputs –
Inputs on page 112).
Device switched off. The device was switched off.
Engine operating hours set to x h . The engine operating hours set to x h .
Failed to change PIN of access
control level "
number ".
Failed to change PIN of access control level " number " (see
Access Control for MIC6 on page 82).
Failed to disable access control. The access control could not be disabled (see Access
Control for MIC6 on page 82).
Failed to enable access control. The access control could not be enabled (see Access
Control for MIC6 on page 82).
Failed to reset all access control
PINs. Failed to reset all PINs for access control (see Access
Control for MIC6 on page 82).