Motortech MIC-Marine, Руководство по эксплуатации

Страница: 137 / 176

8 Settings via the MICT
Rev. 09/2019 137
8.12.6.4 Failure
All system or operational errors cause the engine to be shut down.
Error Description
Alarm shutdown caused by alarm
number .
The engine was shut down by alarm
number
. This
function was defined in the configuration (see
Inputs/Outputs – Alarms on page 108).
Assertion failed (x). An assertion was not adhered to (x). For example, an
assumption for a value was not fulfilled in the firmware. If
the error occurs again after restarting the device, please
contact MOTORTECH.
Critical error x (y). Critical error x (y). If the error occurs again after restarting
the device, please contact MOTORTECH.
Current sensor of output bank
name failed.
The current sensor of output bank
name
failed. Restart
the ignition controller. If the error occurs again after
restarting the device, please contact MOTORTECH.
Cycle signal was missing, so more
trigger signals were counted than
available per cycle. Cycle signal was missing, so more trigger signals were
counted than available per cycle. Check the pickups and
the corresponding configuration (see
Engine – Pickups –
General on page 98). Furthermore, also pay attention to
the instructions in the section entitled Pickup Input Errors
on page 167.
Device started after supply voltage
failure. The device was started after a failure of the supply
voltage. Please check the power supply of the device
where applicable.
General error
number
. General error
number
. An undefined error has occurred.
Restart the ignition controller. If the error occurs again
after restarting the device, please contact MOTORTECH.
General error in pickup pre-
processing on pickup input
PU
number
.
General error in pickup pre-processing on pickup input
PU
number . Check the pickups and the corresponding
configuration (see
Engine – Pickups – General
on page
98). Furthermore, also pay attention to the instructions in
the section entitled
Pickup Input Errors on page 167.
Number of trigger signals
(
number ) counted does not match
the configured value.
Number of trigger signals ( number ) counted does not
match the configured value. Check the pickups and the
corresponding configuration (see
Engine – Pickups –
General on page 98). Furthermore, also pay attention to
the instructions in the section entitled Pickup Input Errors
on page 167.