8 Settings via the MICT
Rev. 09/2019
139
Error
Description
Power output (
x W
) exceeded error
threshold limit (
y W
) at a supply
voltage of
z V
.
The power output (
x W
) exceeded failure threshold (
y W
)
at a supply voltage of
z V
.
Power output (
x W
) exceeded
permanent limit (
y W
) at a supply
voltage of
z V
.
The power output (
x W
) exceeded warning threshold limit
(
y W
) for longer than three minutes at a supply voltage of
z V
.
Self test aborted because pickup
signals have been detected on
pickup input PU
number
.
Self test aborted because pickup signals have been
detected on pickup input PU
number
. Self test can only be
carried out when engine is at a standstill (see
Self Test
on
page 78).
Potential causes:
–
Interference coupling on pickup signal
–
Engine was started
Speed (
x RPM
) exceeded
overspeed limit (
y RPM
) at trigger
signal
number
.
The speed (
x RPM
) exceeded overspeed limit (
y RPM
) at
trigger signal
number
(see
Engine – Pickups – General
on
page 98). The reason for this may also be an interference
coupling on the trigger signal.
Supply voltage failure.
Supply voltage failure. Please check the power supply of
the device where applicable.
Temperature of controller board
(
x °C
) exceeded limit (
y °C
).
The temperature of controller board (
x °C
) exceeded limit
(
y° C
). Ensure that there is sufficient air circulation and/or
cooling.
Temperature of device (
x °C
)
exceeded error threshold limit
(
y °C
).
The temperature of the device (
x °C
) exceeded failure
threshold (
y °C
). Ensure that there is sufficient air
circulation and/or cooling.
Temperature of device (
x °C
)
exceeded permanent limit (
y °C
).
The temperature of the device (
x °C
) exceeded warning
threshold limit (
y °C
) for more than two minutes. Ensure
that there is sufficient air circulation and/or cooling.
Temperature of output board (
x °C
)
exceeded limit (
y °C
).
The temperature of output board (
x °C
) exceeded limit
(
y °C
). Ensure that there is sufficient air circulation and/or
cooling.
Temperature sensor of controller
board failed.
The temperature sensor of controller board failed. Restart
the ignition controller. If the error occurs again after
restarting the device, please contact MOTORTECH.
Temperature sensor of output
board failed.
The temperature sensor of output board failed. Restart
the ignition controller. If the error occurs again after
restarting the device, please contact MOTORTECH.
Содержание MIC-Marine
Страница 1: ...MIC6 Ignition Controller Operating Manual P N 01 10 026 EN Rev 09 2019...
Страница 175: ...Rev 09 2019 175...
Страница 176: ......
