Motortech MIC-Marine, Руководство по эксплуатации

Страница: 17 / 176

Rev. 09/2019 17
3.1 Functional Description
The devices of the MIC6 series are microprocessor controlled ignition systems, each consisting
of a board with a 32 bit main processor (CPU).
Please note that the manufacturer is not required to implement configurations of the ignition
controller for specific engines, and that devices may be delivered without pertinent
configuration.
The ignition controllers of the MIC6 series use information supplied by the pickups to precisely
determine the correct timing for the respective outputs. The pickups can be assigned to two
redundant sets of pickups depending on the device version. The ignition timing is influenced by
various inputs. This can be implemented using analog input signals, a speed characteristic, or
using a serial interface (USB, CAN bus, RS485).
During operation, the ignition controllers continuously monitor the system status of all installed
pickups and the correct operation of the primary ignition circuit by checking the information
received.
Depending on the severity of an error that is detected, the device will shut down immediately or
warn the operator. A corresponding message can be viewed on a connected computer.
To protect the engine, the ignition controllers additionally have an adjustable overspeed shut-
off.
3.2
Applications
The ignition controllers of the MIC6 series are designed for specific 2- or 4-stroke gas engines.
From 1 to max. 24 ignition outputs are available. The device variants are intended for the
following use:
– MIC6: stationary gas engines
– MIC6-Marine: gas engines on ships
The ignition controllers supply the energy required for the corresponding ignition coils of the
gas engines and can supply signals for peripheral equipment.
Any use other than the one described in the operating manual shall be considered improper use
and will result in the voiding of all warranties.
3 Intended Use