Motortech MIC-Marine, Руководство по эксплуатации

Страница: 92 / 176

8 Settings via the MICT
92 Rev. 09/2019
8.11.2 Engine – Cylinder Names
To facilitate the allocation of the cylinders during the configuration of the ignition outputs, you
can individually name each cylinder. The schematic representation of the plan view of the
selected engine supports you in this. Enter the following settings:
– Enable Cylinder Names
Activate the checkbox in order to assign cylinder names. In order to use this function, the
number of cylinders must be defined. Establish the number of cylinders either by using a
configuration from the engine database or by creating a new engine configuration via the
corresponding button. Refer to the section
Engine – Parameters on page 89. If you have
activated the checkbox, the assigned cylinder names must also be assigned to the
corresponding ignition outputs, before the configuration is transferred to the ignition
controller. Otherwise there will be an error message. Refer to the section
Engine – Ignition
Outputs on page 93.
– Bank Name
Enter a name for the respective cylinder bank.
– Cylinder Names
Enter a name for the respective cylinder.