Mitsubishi Electric Q80BD-J61BT11N, Руководство пользователя

Страница: 233 / 362

15 - 5 15 - 5
MELSEC
15 ERROR CODE
Detectability
Error code
(hexadecimal)
Error description Cause of error (details) Corrective action
Master
station
Local
station
B774 Transient request error
The target station was not an intelligent
device station (when the requesting
station is the A8GT-J61BT13 or CC-
Link Ver.2 board).
Check if the target station is an
intelligent device station.
B778 Response timeout
A response was not received from the
requested station (when the requesting
station is the A8GT-J61BT13 or CC-
Link Ver.2 board).
Check the requested module
and cables.
B780
Module mode setting
error
A transient transmission was executed
even though the target station was set
in the I/O mode.
Set the target station in the
intelligent mode.
B801
Access code setting
error An access code/attribute that does not
exist was set. Set the correct access code/
attribute.
B802 Access code error
An access code that does not exist
was used.
Use the correct access code.
B803
Number of data points
error The number of data points is out of
range.
Set the number of data points to
a value in the range from "1 to
960 bytes."
B804
Attribute definition error
Specification error of the
station not supported
transit transmission Invalid attribute definition, or transient
transmission was executed although
the target station does not support
transient transmission.
Review the attribute definition.
Review the specified content of
the target station number. Or,
check the function version and
software version of the target
local station.
B805 Number of data error The number of data is out of rage.
Set the number of data to a
value in the range from "1 to
100" when writing, and "1 to 160"
when reading.
B807 Address definition error
The address was not a multiple of 16
when a bit device was accessed. Set the address to a multiple of
16 when accessing a bit device.
B80D Setting range error
The combination of the set address
and number of points exceeded the
valid processing range. Set so that the number of
processing points does not
exceed the device range.
B814
File register capacity
setting error
The file register capacity was not set. Set the file register capacity.
B815
Module mode setting
error
A transient transmission was executed
even though the target station was set
in the I/O mode.
Change it to the intelligent mode.
B901 E
2
PROM error
When a parameter registration request
(YnA) to E
2
PROM was executed, the
E
2
PROM was faulty or the write limit
(10,000 times) was exceeded.
Replace the module.
B902
Data link startup error
with E
2
PROM
parameters
A data link startup request (Yn8) using
an E
2
PROM parameter was executed
even though the parameter has not
been registered in the E
2
PROM.
Register the parameter to
E
2
PROM with a parameter
registration request (YnA).
B903 Transient request error
A transient request was issued to a
station that has not allocated a
communication buffer area.
Allocate a communication buffer
area with a parameter.
B904
Communication buffer
size setting error
The communication buffer size of the
corresponding station was out of range
when a dedicated instruction was
executed.
Set the communication buffer
size of the corresponding station
within the range.
B905
Transient data length
error
The transient data was longer than the
communication buffer size of the
corresponding station when a
dedicated instruction was executed. Make the communication buffer
size of the corresponding station
larger than the transient data
length.
BA19
Corresponding station
error
The corresponding station that is being
tested stopped communication during
line test.
Check the cable and the
corresponding station.