Mitsubishi Electric Q80BD-J61BT11N, Руководство пользователя

Страница: 13 / 362

A - 11 A - 11
PRECAUTIONS FOR USE
(1) Restrictions for functions depending on the personal computer or
the operating system
There are some restrictions for the functions or supported versions depending
on the operating system or personal computer to be used. For the operating
environment, refer to Section 2.5.
(2) When using the CC-Link Ver.2 board as a standby master station
Refer to Section 2.2 for combinations of modules when using the CC-Link
Ver.2 board as a standby master station.
(3) When using the CC-Link Ver.2 board as a master station
When using the CC-Link Ver.2 board as a master station, any of local modules
cannot be used as a standby master station.
(4) Restrictions on the CC-Link Ver.2 board installation
Installing the CC-Link Ver.2 board and CC-Link Ver.1 board to the same
computer and using both of them is not allowed.
(5) Installation
When a CC-Link Ver.2 board is used on a personal computer in which
SWnDNF-CCLINK has been installed, uninstall SWnDNF-CCLINK first, then
install the SW1DNC-CCBD2-B that is provided with the CC-Link Ver.2 board.
(6) Driver installation and updating
Do not install or update the driver other than the way written in the
troubleshooting in this manual.
The consistency between the driver and utility cannot be identified, and CC-
Link Ver.2 board may not operate properly.
(7) Software versions of the CC-Link system master and local modules
When reading/writing data from/to other stations using the transient
transmission function in the CC-Link system, there is the restriction for the
software version for the CC-Link master and local modules in the following
table.
Model name Software version Remark
AJ61QBT11
Version N or later
Not accessible if the software
version is M or earlier.
A1SJ61QBT11
AJ61BT11
A1SJ61BT11
(8) Transient transmission functions of the CC-Link board
Transient transmission is not allowed to slave station No.64 on the CC-Link
system.
(9) Performance
The system performance using the CC-Link Ver.2 board differs according to
the performance/loaded condition of the personal computer, the processing
contents of the application software, and the type of the interface board. Use
the product after reviewing the system configuration and processing contents of
the software in advance.
For details of the CC-Link Ver.2 board performance, refer to Appendix 3 DATA
LINK PROCESSING TIMES.
(10) Combination of ROM version and S/W version
When using CC-Link Ver.2 board ROM version 2B or later, use S/W package
version 1.06G or later.