Mitsubishi Electric MR-J4W2, Инструкция по эксплуатации

Страница: 24 / 542

1. FUNCTIONS AND CONFIGURATION
1 - 7
Model MR-J4W3- 222B 444B
Functional safety STO (IEC/EN 61800-5-2) (Note 6)
Safety
performance
Standards certified by
CB
EN ISO 13849-1 PL d (category 3), IEC 61508 SIL 2, EN 62061 SIL CL2
Response
performance
8 ms or less (STO input off → energy shut off)
(Note 5) Test pulse
input (STO)
Test pulse interval: 1 Hz to 25 Hz
Test pulse off time: Up to 1 ms
Mean time to
dangerous failure
(MTTFd)
100 years or longer
Diagnosis converge
(DC)
Medium (90% to 99%)
Average probability of
dangerous failures
per hour (PFH)
1.68 × 10
-10
[1/h]
Compliance
to standards
CE marking
LVD: EN 61800-5-1
EMC: EN 61800-3
MD: EN ISO 13849-1, EN 61800-5-2, EN 62061
UL standard UL 508C
Structure (IP rating) Force cooling, open (IP20)
Close mounting Possible
Ambient
temperature
Operation
0 °C to 55 °C (non-freezing)
Storage
-20 °C to 65 °C (non-freezing)
Environment
Ambient
humidity
Operation
90% RH or less (non-condensing)
Storage
Ambience Indoors (no direct sunlight), free from corrosive gas, flammable gas, oil mist, dust, and dirt
Altitude Max. 1000 m above sea level
Vibration 5.9 m/s
2
or less at 10 Hz to 55 Hz (directions of X, Y and Z axes)
Mass [kg] 1.9
Note 1. 0.45 A is the value applicable when all I/O signals are used. The current capacity can be decreased by reducing the number of
I/O points.
2. Reusable regenerative energy corresponds to energy generated under the following conditions.
Rotary servo motor: Regenerative energy is generated when the machine, whose moment of inertia is equivalent to the
permissible charging amount, decelerates from the rated speed to stop.
Linear servo motor: Regenerative energy is generated when the machine, whose mass is equivalent to the permissible
charging amount, decelerates from the maximum speed to stop.
Direct drive motor: Regenerative energy is generated when the machine, whose moment of inertia is equivalent to the
permissible charging amount, decelerates from the rated speed to stop.
3. Moment of inertia when the machine decelerates from the rated speed to stop
Moment of inertia for three axes when three motors decelerate simultaneously
Moment of inertia for each axis when multiple motors do not decelerate simultaneously
The values also apply to the direct drive motor.
4. Mass when the machine decelerates from the maximum speed to stop
The primary-side (coil) mass is included.
Mass for three axes when three motors decelerate simultaneously
Mass for each axis when multiple motors do not decelerate simultaneously
5. Test pulse is a signal which instantaneously turns off a signal to the servo amplifier at a constant period for external circuit to
self-diagnose.
6. STO is common for all axes.
7. The command communication cycle depends on the controller specifications and the number of axes connected.
8. Servo amplifier with software version A3 or later is compatible with the command communication cycle of 0.222 ms. However,
note that the following functions are not available when 0.222 ms is used: auto tuning (real time, one-touch, and vibration
suppression control), adaptive filter II, vibration tough drive, and power monitoring.
9. This value is applicable when a 3-phase power supply is used.