Microchip Technology GridTime 3000, Руководство по установке

Страница: 30 / 302

☐
Review all safety documentation and procedures
☐
Unpack the unit and accessories — 6.3. Unpacking the Unit
☐ Install the device in the rack — 6.4. Rack Mounting the GridTime 3000
☐
Install an antenna system — 6.7. Installing the GNSS Antenna
☐ Connect all signal cables and connectors — 6.6. Signal Connections
☐
Connect safety ground, then power connections — 6.5. Making Ground and Power Connections
☐
Power the device — 6.8. Powering the GridTime 3000
☐ Configure the device using the CMT or SNMP — 7. Clock Management Tool (CMT) , 8. Simple Network
Management Protocol (SNMP)
6.3 Unpacking the Unit
This section describes how to unpack the GridTime 3000 and its accessories from the box it was shipped in.
When unpacking the device, perform the following steps:
1. Inspect the box for damage before opening. If the box has sustained damage, take photos of the damage
immediately and check the packed items for damage.
2. Remove each item from the packaging. Check the package for small items including adapters and antennas.
3. Visually inspect each item for damage. If any item is damaged, take photos of the damage immediately and
contact technical support. See
11.10. Contacting Technical Support .
4. Check each item on the purchase order to confirm the correct items were shipped and received.
5. Validate that the product code matches what has been ordered
If the items have sustained physical damage or if an item is missing, please contact support. See 11.10. Contacting
Technical Support .
Note: Licenses ordered at the time of manufacture are installed on the device and a paper copy of the license is not
provided.
6.3.1 Product Label
This section describes the information on the GridTime 3000 product label, and where the label can be found on the
device.
The product label is located on the top lid directly above the SFP ports. See 6.3.1. Product Label for a description of
the information on the label.
Figure 6-3. Product Label
6.4 Rack Mounting the GridTime 3000
This section describes the process for rack mounting the GridTime 3000.
The GridTime 3000 has been designed to be installed in a 19-inch rack. It is 1U (1.75 Inch) high and has two rack
mounting tabs at the front to provide rack mounting holes.
1. Insert the GridTime 3000 so the LCD is facing out of the rack. This will place the mounting fins at the front of
the rack.
Installation
©
2022 Microchip Technology Inc.
and its subsidiaries
Manual
DS00004572A-page 30