8.
Save Settings
Click the 'SAVE' button to write the settings to the GridTime 3000.
A 'Saved!' notification will appear in the bottom right corner of the page indicating that the settings have
successfully been written to the GridTime 3000.
9.10
Provisioning the Alarm Relay Ports
This section describes how to provision the Alarm Relay Ports.
The Alarm Relays configuration tab is used to map alarms to the GridTime 3000's Alarm Relay ports.
When any of the alarms mapped to an Alarm Relay port becomes active, the port transitions from the non-alarm state
to the alarm state. When all active alarms on an Alarm Relay port clear, the port transitions from the alarm state to
the non-alarm state.
See
11.4.1. Alarm Conditions and Correction Actions
for the trigger and clearance conditions of all the GridTime
3000's alarms.
Follow the steps below to provision the GridTime 3000's Alarm Relay ports.
1.
Navigate to Alarm Relay Port Window For Port 1
Navigate to the window for the port you want to configure by clicking on the Alarm Relays icon, then clicking
the settings bar corresponding to Alarm Relay 1 or 2 (Port 16 or Port 17) .
1. Click Here to
Alarm Relay Ports
Configuration Tab
2. Click Here to
Bring Up Alarm
Relay Port
Port Window
3. Alarm Relay Port
Window will Appear
Provisioning
©
2022 Microchip Technology Inc.
and its subsidiaries
Manual
DS00004572A-page 186
