A 'Saved!' notification will appear in the bottom right corner of the page, indicating that the settings have
successfully been written to the GridTime 3000.
9.7.2
Provisioning J1 Output
This section describes how to provision a T1/E1/J1 Port to output a J1 signal.
1.
Select Output
Select 'J1' from the 'SELECT OUTPUT' dropdown. This will reveal the J1 specific configuration options.
Note:
As the T1/E1/J1 ports must both output the same signal type (T1, J1, or E1), the signal output type for
both ports is only configurable in the port 1 configuration window.
2.
Enable Port
Select 'ENABLE SIGNAL (LOW IMPEDANCE)' from the 'HIGH IMPEDANCE OUTPUT' radio buttons. This will
reveal the J1 output specific settings.
3.
Select Framing Format
Select the appropriate 'FRAMING FORMAT' option from the 'FRAMING FORMAT' dropdown. By default the
'FRAMING FORMAT' is set to none.
4.
Select Encoding Type
Select the encoding type from the 'ENCODING TYPE' dropdown. By default, the 'ENCODING TYPE' is set to
Bipolar 8-Zero Substitution.
Provisioning
©
2022 Microchip Technology Inc.
and its subsidiaries
Manual
DS00004572A-page 157
