MASCAR Diavel 630, Руководство по эксплуатации и обслуживанию

Страница: 57 / 72

Roundbaler DIAVEL 630
– DIAVEL 630 CUT
USE AND MAINTENANCE MANUAL - 57 -
explanation on what to do in case of repair or
maintenance.
6.4.1 Lifting through jacks
To carry out the operations of substitution of the
tires or intervention on the axle, may be
necessary to lift the rear part of the round baler.
If no cranes are available for lifting using the
upper lifting points, it is possible to lift the rear of
the baler using one or two jacks positioned under
the framework of the axle.
Before use, make sure that the lifting capacity of
the jacks is adequate for the weight of the
machine (par. 1.7).
DANGER
It is absolutely forbidden to lift the baler using
jacks to a height of over 10 cm. As this can
lead to loss of stability of the machinery and
heavy loads on the support bracket.
Fig. 44
– Lifting points for the jacks
WARNING
The jacks must be fitted with suitable supports
or one side in contact with the round baler
made of a non-slip rubber in order to avoid
dangerous heeling of the lifted part.
WARNING
Use the lifting by jacks only for interventions
on the machine made by trained personnel. Do
not leave the machine on jacks for parking or
for a period longer than 2 hours.
6.5 MACHINE SETTINGS
The following are all the settings which can be
carried out in a machine.
The round baler comes from the factory with
settings made correctly, proceed with the settings
only if you have problems or malfunctions.
6.5.1 Sensors
The round baler uses inductive sensors for
detecting the state of the machine. These sensors
detect when a metal object is located at a
distance from less than 4 millimeters.
In addition to these sensors, the machine is
equipped with two pressure switches which detect
the pressing of the bale pressure. These pressure
switches are located in the hydraulic block on the
right side of the machine, connected to the
cylinders of the gate and the front pressure
gauge.
The pressure switches are calibrated by the
manufacturer and cannot be modified.
A third pressure switch is present in the hydraulic
block that handles the knives (cut version).
You can check the operation of the sensor via the
terminal:
Menu> Settings> Input Diagnostics
In this menu there is a list of the machine inputs
followed by a symbol to indicate whether they are
activated or not.
To verify the correct operation of inductive
sensors just bring a metal object to the sensor
head and check the activation status.
All inductive sensors on the machine must
adjusted to a 2 mm distance from the detection
area.
The following chart lists the inputs of the machine.
N° Sensor Description
SW1 P1 Signal pressure switch 1
SW2 P2 Signal pressure switch 2
SW3 Pcut Signal pressure switch
knives
DIG1 Drop bottom Sensor closed drop bottom
DIG2 Rear door Sensor closed rear door
DIG3 Knives
(right)
Sensor knives (right side)
DIG4 Knives (left) Sensor knives (left side)
DIG5 Net cutting Armed net cutting blade