MASCAR Diavel 630, Руководство по эксплуатации и обслуживанию

Страница: 26 / 72

Roundbaler DIAVEL 630
– DIAVEL 630 CUT
USE AND MAINTENANCE MANUAL - 26 -
When the twine spools are set, make sure that the
writings on them are straight in order to avoid the
twisting of the twine may cause malfunctions to
the binder.
To ease the sliding of the twine through the
various passages it is necessary to join the two
twines heads together with the kind of knots
shown hereunder in the picture.

(A) Sisal (vegetable)

(B) Synthetic
Fig. 11
– Kinds of knots
4.8 BALE DISCHARGE
Once the collection of the material and the twine
or net binding has been done, open completely
the rear door in order to discharge the bale.
WARNING
Make sure that there are no people around the
machine and discharge the bale on a flat
terrain.
The bale ejector (optional) has been foreseen in
order to kick away the bale while discharging it
allowing to close the rear door without having to
drive backwards.
WARNING
Don’t use the bale ejector on steep slopes.
Danger of rolling downhill.
WARNING
In case of operating on slope terrains there
might be the danger that the bale rolls
downhill once it has been discharged. A bale
rolling gets out of control and can cause
severe damages to people or things. Always
discharge the bale perpendicularly to the
slope in order to avoid the rolling.
4.9 BALER STOP
At the job end, the operator must:

Stop the run of the tractor on plain and use
the parking brake.

Remove the PTO shaft from the tractor.

Switch off and disconnect the display.

Lift up the pickup.

Stop the engine.

Fix the pickup in a upper position using the
related chain.

Make sure that the rear door is closed and all
the parts of the machine are completely
stopped in a steady position.

Let the standing foot down until it reaches the
ground.

Disconnect the various connections: oleo
dynamic pipes and electric cables.

Remove the PTO shaft from the PTO of the
tractor.

Remove the pin from the eye of the draw bar.
WARNING
Check that the surface on which the standing
foot has been placed, is steady and compact
enough to support its weight.
Now it is possible to switch on the tractor again
and move it somewhere else.
4.10 PARKING

Before placing the round baler in its
warehouse on a flat and suitable surface,
make sure that the material has been
completely discharged.

Put the standing foot in contact with the
ground.

Put suitable brake blocks under the tires and
make sure that all the protections of the
machine are in the correct position.

Stop the tractor and use the parking brake.

Once the tractor and the other parts are
completely stopped, remove the PTO shaft
from the PTO of the tractor.

Place the PTO shaft on suitable supports so
that both the PTO shaft and its protections
won’t be damaged.

Release the pressure of the hydraulic circuit.