MARUTI SUZUKI BALENO 2017, Руководство пользователя

Страница: 35 / 324

2-17
BEFORE DRIVING
68PH0-74E
(If the shock sensor is in the enabled state)
• If the vehicle feels a shock higher than
the pre-warning sensitivity, the siren
sounds for about 2 seconds (pre-warn-
ing). If the vehicle feel a shock higher
than the full blast warning sensitivity, all
turn signal lights start to blink and the
interior buzzer beeps intermittently. After
5 seconds, the siren will sound for about
27.5 seconds (Full blast warning). The
security system indicator continues to
blink during this time.
NOTE:
If you set the full blast warning sensitivity
higher than the pre-warning sensitivity in
the setting mode of the information display,
or the vehicle feels such shock as to be
able to trigger the full blast warning, the full
blast warning will be triggered preferen-
tially. In this case, the pre-warning will not
be triggered.
When disabled
When the system is disabled, it stays dis-
armed even if you perform any system
arming operation.
How to switch the state of the security
system
When the security system has been
already disarmed, you can switch the sys-
tem from the enabled state to the disabled
state, and vice versa, using the following
method.
1) Sit in the driver’s seat and make sure
that all doors, tailgate and engine hood
are closed.
• If any door is open, the open door
warning light comes on.
68PH00219
2) (Vehicle with keyless push start sys-
tem only)
Turn the lock knob (1) on the driver’s
door rearward (2).
68PH00220
3) Turn the knob on the lighting control
lever to the OFF position (3).
NOTE:
The following steps 4) and 5) must be
completed within 15 seconds.
68PH00221
(1)
(2)
EXAMPLE
(3)
EXAMPLE
OFF
4 times
EXAMPLE