5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 255 of 356 (
D99875607-91
)
Figure 5-111 - Tipper Heater Plug (TOP VIEW)
12)
Unplug the top motor connector on the left side of the tipper module.
Figure 5-112 - Tipper Top Motor Connector (FRONT VIEW)
13)
Use the 5/32” and 1/8” hex wrenches to remove the four sets of screws and washers that secure the
module to the top deck plate, shown in
14)
Use both hands to pull the tipper module toward the front of the device several inches to give room to
disconnect the cables plugged in to the breakout circuit board mounted to the exit transport module
behind it (see
). Pay careful attention to any nearby wires as you pull it forward.
