6 - Adjustments
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 342 of 356 (
D99875607-91
)
6.7
How to Calibrate the Indenter Module
6.7.1
About Calibrating the Indenter Module
The indenter module in the ExpressCard embosser moves between three positions:
LOAD
position: During normal operation, it is “parked” below the embosser.
HOME
position: During rear indent operations, it moves out of the embosser and places the ribbon
between the characters on the embosser wheel.
UNLOAD
position: When removing the indent cartridge, it moves all the way out for easy removal.
If the indent ribbons are aligned such that indented characters are too far toward one edge of the indent
ribbon, follow the steps in this section to re-align the indenter.
6.7.2
How to Calibrate the Rear Indent Cartridge Positions
To calibrate the indent position of the indenter, follow these steps:
1)
On the touchscreen, create a sample card using sample 3 in
Menu
>
Samples
.
2)
Navigate to
Menu
>
Settings
>
Service
>
MCP Cmds
to open the
Controller Commands
page.
3)
Under the “Indenter Move” button, select
Bot Cartridge Unload
in the dropdown list.
4)
Press the
Indenter Move
button. The device will move the indenter to the unload position.
