5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 219 of 356 (
D99875607-91
)
Figure 5-84 - Safe Removal Position for Embosser Cable (TOP VIEW FROM LEFT)
10)
In each of the following steps, rotate the embosser wheel so only empty tines are near the hex wrench.
This saves time if the hex wrench slips and breaks a tine; if the broken tine were not empty, you
would have to re-install the font to another tine and re-map it in the software.
11)
Use the 1/8” hex wrench to remove the three screws that attach the indent module to the embosser,
shown in
Figure 5-85 - Unfastening Indent Module (TOP VIEW FROM REAR)
12)
Use the 5/32” ball-end hex wrench to remove the four screws and washers that attach the embosser to
the top deck plate, and set them aside. The left image in
the front of the device, and the right image shows the other two as seen from the rear of the device.
