5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 318 of 356 (
D99875607-91
)
5.36.2
Remove
To remove the touchscreen, follow these steps:
1)
If you are replacing any modules that do NOT require silicone adhesive, replace those first. That will
reduce the risk of breaking the touchscreen's adhesive during other service.
2)
Prepare the device for replacing parts by following the steps in section
Device for Removing / Re-installing Modules
. At the end, the device should be powered down with
all external cables safely disconnected and the hopper shuttle parked near the front of the device.
3)
Remove the cover by following the steps in section
5.3 How to Remove / Re-install the Cover
4)
Place the cover on a protected surface with the touchscreen toward the floor.
5)
Use the No. 2 Phillips screwdriver to remove the four screws holding the touchscreen retaining plate
to the cover (see
) and set them aside.
Figure 5-177 - Touchscreen Retaining Plate Screws (REAR VIEW)
6)
Remove the touchscreen retaining plate and set it aside.
7)
Remove the touchscreen and set it aside.
