6 - Adjustments
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 331 of 356 (
D99875607-91
)
a)
Use the
Rnl
command to read the current setting for the X size.
b)
Use the
Pnl;=;number
command, where
number
is 1-4 steps larger than the original value
reported by
Rnl
, to add rows to the right edge of the image, bringing it closer to the right edge of
the card.
c)
Create a set of test cards that represent the full range of the application’s images.
d)
If test cards are created successfully, repeat the process of increasing the X size.
e)
If the ribbon breaks or the printer produces blank cards, lower the value closer to where it was to
start, and re-try test cards until they are created successfully.
7)
Raise the Y (up-down) position of the image on the card by following these steps:
a)
Use the
Ry
command to read the current setting for the Y position.
b)
Use the
Py;=;number
command, where
number
is 1-4 steps smaller than the Y value reported
by
Ry
, to bring the top edge of the image closer to the top edge of the card.
c)
Create a set of test cards that represent the full range of the application’s images.
d)
If test cards are created successfully, repeat the process of raising the Y position.
e)
If the test cards show wrinkled edges or other problems, raise the value closer to where it was to
start, and re-try test cards until they are created successfully.
8)
Increase the Y size (height) of the image on the card by following these steps:
a)
Use the
Rnw
command to read the current setting for the Y size.
b)
Use the
Pnw;=;number
command, where
number
is 1-4 steps larger than the original value
reported by
Rnl
, to add rows to the bottom edge of the image, bringing it closer to the bottom
edge of the card.
c)
Create a set of test cards that represent the full range of the application’s images.
d)
If test cards are created successfully, repeat the process of increasing the Y size.
e)
If the test cards show wrinkled edges or other problems, lower the value closer to where it was to
start, and re-try test cards until they are created successfully.
