5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 217 of 356 (
D99875607-91
)
Figure 5-80 - Lifting the Replacement Embosser Out of the Box
5)
Use the 7/16” combo wrench (and the 5/32” hex wrench if necessary) to remove the nuts holding the
replacement embosser to the bottom of the box as shown in
. Set the hardware aside in
the bottom of the box for later re-packaging.
Figure 5-81 - Unfastening the Replacement Embosser from the Box
6)
Lift the embosser out of the bottom of the box.
7)
Use the pliers and the 1/8” hex wrench to remove the three nuts and bolts holding the indenter to the
embosser, if any (see
). Set the hardware aside in the bottom of the box.
Figure 5-82 – Nuts and Bolts Holding Indenter to Embosser
