5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 308 of 356 (
D99875607-91
)
5.33.3
Re-install
To re-install the power supply, follow these steps:
1)
If the device is no longer positioned for access to the power supply screws:
a)
Take appropriate steps to protect the work surface the ExpressCard is on.
b)
With a partner, safely and carefully move the ExpressCard’s left side off the edge of the surface it
sits on, only until the four power supply screws on the bottom of the device are exposed (see
). Do not move the device any further off the edge than is absolutely
necessary.
One person MUST hold the device at all times to keep it stable on the work
surface.
2)
Put the power supply back into the device and line up its screw holes with the four screw holes on the
bottom of the device.
3)
Screw in and tighten the four screws.
4)
Re-connect the output wires according to
5)
Plug in the control and monitoring cable.
6)
Re-connect the input wires. Insert the spade connectors
behind the plate behind the screws
(not
directly behind the screws). See
. The connections are as follows:
a)
The green ground wire goes nearest the rear of the device.
b)
The black wire goes in the middle.
c)
The white wire goes nearest the front of the device.
7)
Snap the clear plastic cover in place to cover the input wires.
8)
With a partner, safely and carefully move the device back to a stable operating position.
9)
Replace the left side access door by following the steps in section
5.7 How to Remove / Re-install
10)
Perform any additional service that requires the device to be powered off and open.
11)
Re-attach the power cable, network cable, and any security hardware.
12)
Power on the device.
13)
On the touchscreen, navigate to
Menu
>
Samples
, create a sample card, and make sure the device
functions properly and the sample looks correct. If the device does not power on or function
properly, contact MagTek Support Services (see
).
