Magtek ExpressCard 2000, Руководство по обслуживанию оборудования

Страница: 209 / 356

5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 209 of 356 ( D99875607-91 )
5.20.2 Remove
To remove the XY transport module’s ribbon cable, follow these steps:
1)
Prepare the device for replacing parts by following the steps in section 5.1 How to Prepare the
Device for Removing / Re-installing Modules . At the end, the device should be powered down with
all external cables safely disconnected and the hopper shuttle parked near the front of the device.
2) Open the top access door by following the steps in section 2.7 How to Open the Top Access Door .
3) Move the XY transport to the front of the device to expose its cable and its connection to the circuit
board (“breakout board”) on the base plate of the device (see
Figure 5-71 and section 2.8 How to
Safely Move Transports By Hand ).
Figure 5-71 - XY Transport at Front of Device Exposing Circuit Board (TOP VIEW)
4) On the rear side of the XY transport, locate the two retaining clips that secure the ribbon cable to the
transport. Lift both clips firmly toward the ceiling to unlock and eject the cable from the circuit
board, then disconnect the ribbon cable. See
Figure 5-72 .