5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 89 of 356 (
D99875607-91
)
Figure 5-20 - Silver Portion of Cover Properly Seated (REAR LEFT VIEW)
12)
Make sure the two sides of the cover roughly line up with their screw holes. This will align the screw
holes in the front of the cover.
13)
Use your fingers or the magnetic retriever tool to insert the two screws that fasten the cover to the
front of the device (see
). Push them gently into place to constrain the cover from
moving left to right.
14)
Use a screwdriver or the magnetic retriever tool to insert the two screws that fasten the cover to the
rear plate (see
) to constrain the cover from moving front to rear.
15)
Fully insert the eight screws that fasten the cover to the base. Follow these helpful hints:
a)
Put a light below the screw holes before attempting to line them up.
b)
Use your free hand to push the cover into the right position to insert the screws.
c)
It may be helpful to use the magnetic retriever tool to insert them into the holes, then use the
screwdriver or a finger to push them all the way in.
16)
One by one, line up each of the plastic fastener plates below their matching screws, hold them in
place, and tighten the screws. The diagonal portion of each fastener plate will be in the midline of the
device as shown. Follow these helpful hints:
a)
The easiest tool to tighten the front corner screws is a screwdriver with a heavy-duty flex
extension. If one is not available, they may be easier to tighten using the No. 1 screwdriver
leaned flush against the inside corner of the cover’s top opening.
b)
For each plate, fasten the midline screw first, then the corner screw.
c)
Look into the cover from above to put the screwdriver firmly into the screw head first, then
crouch next to the device to line up the plate, then tighten the screw partway.
d)
Do not push the plates too hard toward the ceiling, or you may pop the screw out of its hole.
e)
Screw both screws partway into the plate before tightening them all the way.
