5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 90 of 356 (
D99875607-91
)
Figure 5-21 - Front Left Fastener Plate (LEFT VIEW)
17)
Tighten the remaining loose screws EXCEPT the top rear right (you will tighten that after re-
installing the top access door).
18)
Re-install the magnetic stripe reader by following the steps in section
install the Magnetic Stripe Reader (MSR) Module
19)
Re-install the top access door by following the steps in section
5.5 How to Remove / Re-install the
20)
Complete any other service that requires the device to be powered off and open.
21)
Power on the device and test it, paying special attention to the following:
a)
Test the touchscreen and manual feed slot light and functionality by creating a sample card from
the manual feed slot using the touchscreen.
b)
Make sure the device shows
Offline
on the
Status
page when the top access door is open.
c)
Test the electronic latches by testing the remote unlock function.
22)
If the device does not power on or function properly, contact MagTek Support Services for assistance
(see
