5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 256 of 356 (
D99875607-91
)
Figure 5-113 – Circuit Board Behind Tipper and Exit Ramp Module (TOP VIEW FROM FRONT)
15)
Disconnect the following connectors from the circuit board behind the tipper, working from the left
side of the device to the right side. Use
as a reference, and keep track of which cable
connected to which connector:
a)
From connector
J4
on the board, disconnect the Tipper Foil Advance Motor cable.
b)
From connector
J3
on the board, disconnect the Tipper Cog Grip Motor cable.
c)
From connector
J15
on the board, disconnect the Tipper RTD cable.
d)
From connector
J14
on the board, disconnect the Tipper Heater cable.
e)
From connector
J17
on the board, disconnect the Tipper Foil Advance Hall Sensor cable.
f)
From connector
J12
on the board, disconnect the Exit Fan cable.
g)
From connector
J8
on the board, disconnect the Tipper Card Grip Sensor cable.
h)
From connector
J7
on the board, disconnect the Tipper Cam Home Sensor cable.
i)
From connector
J9
on the board, disconnect the Tipper Card Exit Sensor cable.
