IBM 866251Y - Netfinity 5500 M20, Руководство по техническому обслуживанию аппаратной части

Страница: 40 / 386

Save settings:
After you make configuration changes, review them to be
sure that they contain the correct information. If the
information is correct, select Save Settings to save the
selected changes.
Restore settings:
After you make configuration changes, review them to be
sure that they contain the correct information. If the
information is incorrect, or if you do not want to save these
changes, select Restore Settings to delete the changes
and restore the previous settings.
Load default settings:
If you make configuration changes and then decide that
you want to use default values instead, select Load
Default Settings to cancel the changes and restore the
factory settings.
Exit setup:
Select to exit from the Configuration/Setup Utility program.
If you have made any changes, you will be asked if you
want to make the changes or exit without making the
changes.
Configuring options
Before installing a new device or program, read the
documentation that comes with it. Reading the instructions
helps you to determine the steps that are required for
installation and configuration. The following list provides a
preview of the actions that might be required to configure
the server.
1. Run the Configuration/Setup Utility program and
record the current configuration settings.
See “Configuration/Setup Utility program” on page 21.
2. Set jumpers or switches on the server system board.
See “Changing jumper positions” on page 176 and
“System board jumpers” on page 280.
3. Set jumpers or switches on the device.
See the instructions that came with the adapter.
4. Install the adapter in the server.
See “Adapters” on page 161.
5. Install software programs.
See the installation instructions that came with the
software.
6. Resolve configuration conflicts.
See “Resolving configuration conflicts” on page 33.
32
Netfinity Server HMM