IBM 866251Y - Netfinity 5500 M20, Руководство по техническому обслуживанию аппаратной части

Страница: 123 / 386

This operation is useful when you want to start over and
create a new configuration.
To initialize the adapter or controller:
1. Select the icon on the Tool Bar or select
Adapter Configuration from the Advanced pull-down
menu. A screen similar to the following appears.
2. Select Initialize Adapter Configuration.
Attention
After you initialize the configuration, you will not
have access to any data stored on the logical
drives attached to the selected ServeRAID
adapter or controller.
This choice deletes the existing configuration
information, sets all functional hard disk drives
attached to the controller to the Ready state, and
deletes all logical drives defined for the controller.
This choice does not change any of the ServeRAID
adapter or controller settings (such as the stripe-unit
size, rebuild rate, and so on) from their current or
customized values.
3. Select OK.
Scanning for new drives:
You can scan for new
devices attached to the ServeRAID adapter or controller.
To scan for new drives, select the icon on the Tool
Bar or select Scan For New Drives from the Advanced
pull-down menu.
ServeRAID monitoring functions
This section contains instructions for using the
Administration and Monitoring Program to monitor the
ServeRAID adapter and controller status information, event
logs, logical drive information, and physical device
information.
Monitoring adapter status information:
A green or red light on the screen indicates the currently
active adapter button. (Green indicates that the
ServeRAID adapter or controller is responding and red
Netfinity 5500 M20 - Type 8662
115