IBM 866251Y - Netfinity 5500 M20, Руководство по техническому обслуживанию аппаратной части, Страница: 136 / 386

HSREBUILD Use the HSREBUILD command to set the
ServeRAID adapter or controller hot-swap
rebuild feature on. Use a question mark (?)
to display the current status of the hot-swap
rebuild feature.
Supported operating systems: Windows NT,
OS/2, NetWare, OpenServer, UnixWare, and
DOS
Command:
IPSSEND HSREBUILD
Controller Options
Replace:
Ÿ
Controller with the ServeRAID controller
number (1 to 8)
Ÿ
Options with ON to enable the hot-swap
rebuild feature, or ? to display the status
of the hot-swap rebuild feature.
ServeRAID IPSMON program (starting)
You can run the IPSMON program from the operating
system command line.
To start the IPSMON program:
Ÿ
If you are using OS/2 or Windows NT:
1. Type:
c:
\ipsadm\ipsmon
2. Press Enter.
Note
The c represents the drive where OS/2 or
Windows NT is installed.
Ÿ
If you are using Novell NetWare:
1. From the console, type:
load ipsmon
2. Press Enter.
Ÿ
If you are using SCO OpenServer or UnixWare:
1. Type:
/usr/bin/ipsmon
2. Press Enter.
ServeRAID IPSMON program (using)
When you start this monitoring program, it immediately
begins polling all ServeRAID adapters and controllers for
specific conditions. If a condition being monitored is found,
this program logs a message to the monitor, to a file, or to
both the monitor and a file.
The IPSMON program uses command-line parameters to
determine where to log the messages. If you need help,
you can type the
IPSMON -?
command for a list of valid
parameters.
128
Netfinity Server HMM