Harris Platinum Z16HD+, Предварительное руководство

Страница: 70 / 260

3-2 888-2586-001 9/15/06
WARNING: Disconnect primary power prior to servicing.
Platinum Z16HD+ Section 3 Operator Guide
3.2 Transmitter Controls
The transmitter controls are mostly on the right half of the controller front panel at the
top of the transmitter, See Figure 3-1. These controls and their function are listed below.
OFF - Used to turn the transmitter off.
ON HIGH - Turns the transmitter on to the previous HIGH setting which is set by
pressing the POWER Up/Down buttons. If the transmitter has folded back power
automatically, due for instance to high VSWR, pressing the HIGH button will return the
transmitter to the normal high power level provided the cause of the foldback is gone.
ON LOW - Turns the transmitter on to the previous LOW setting which is set by
pressing the Power Up/Down buttons. If the transmitter has folded back power
automatically, due for instance to high VSWR, pressing the LOW button will return the
transmitter to the normal low power level provided the cause of the foldback is gone.
POWER (up/down arrows) - used to raise and lower the transmitter power.
REMOTE DISABLE - (Located on the left side of the controller) used to disable any
remote control system which is connected to the transmitter. When the LED is lit, the
remote control inputs are disabled.
NOTE:
Some of the less often used transmitter controls, such as calibration and configu-
ration, are located in the menu screens of the Diagnostics Display system which
is covered later in this section.
3.3 Transmitter Metering
There are five function keys below the Transmitter display on the front of the controller:
•
FWD PWR (Forward Power)
•
RFL PWR (Reflected Power)
•
PA Amps
•
PA Volts
•
APC (Automatic Power Control)
These are dedicated metering selections for the 5 most important transmitter
parameters. The Diagnostic Display will provide all other necessary metering, while
still being able to monitor these five readings.