GE Power Quality Meter Series, Инструкция по эксплуатации

Страница: 73 / 282

GE Power Management PQM Power Quality Meter 4-17
4 PROGRAMMING 4.2 S1 PQM SETUP
4
4.2.11 PROGRAMMABLE MESSAGE
Figure 4–11: SETPOINTS PAGE 1 – PQM SETUP / PROGRAMMABLE MESSAGE
PROGRAMMABLE MESSAGE: A 40-character message can be programmed using the keypad, or via a
serial port using PQMPC. An example of writing a new message over the existing one is shown below:
TIPS:
• The setpoint access must be enabled in order to alter the characters.
• To skip over a character press the key.
• If a character is entered incorrectly, press the key repeatedly until the cursor returns to the posi-
tion of the error, and re-enter the character.
• To select this message as a default message, see Section 3.4: DEFAULT MESSAGES on page 3–8.
A copy of this message is displayed in actual values page A1 under
PROGRAMMABLE MESSAGE
.
]] SETPOINTS
]] S1 PQM SETUP
PHONE: 905-294-6222
GEindustrial.com/pm
]] SETPOINTS
]] S2 SYSTEM SETUP
SETPOINT
] PREFERENCES
]
Range: 40 alphanumeric characters
] PROGRAMMABLE
] MESSAGE
] TRACE MEMORY
]
M E S S A G E
M E S S A G E
M E S S A G E
] PROGRAMMABLE
] MESSAGE
PHONE: 905-294-6222
GEindustrial.com/pm
NEW SETPOINT
STORED
MESSAGE
PHONE: 905-294-6222
GEindustrial.com/pm
NEW SETPOINT
STORED
S T O R E
S T O R E
VALUE
U S E T H E V A L U E
K E Y S T O S E L E C T T H E
U N D E R L I N E D
Q U A N T I T I E S
Displayed for 3 seconds when
STORE key pressed
Displayed for 3 seconds when
STORE key pressed
S T O R E
S T O R E