GE Power Quality Meter Series, Инструкция по эксплуатации

Страница: 260 / 282

A-10 PQM Power Quality Meter GE Power Management
A.1 PQM APPLICATION NOTES APPENDIX A
A
Any sample that deviates from its corresponding reference sample by the amount V
k 2
for a minimum duration
as calculated above is detectable by the PQM.
EXAMPLE:
Consider a PQM with a nominal VT secondary voltage of 100 V into the VT inputs. The trace memory trigger
for a Phase A undervoltage level of 90 V is enabled with the following setpoints:
S2 SYSTEM SETUP \ CURRENT/VOLTAGE CONFIGURATION \ VT NOMINAL SECONDARY VOLTAGE: 100 V
S1 PQM SETUP \ TRACE MEMORY \ VA UNDERVOLTAGE TRIG LEVEL: 90%
In the waveform below, an undervoltage fault occurs in the second cycle. The first cycle RMS voltage is 100 V;
the second cycle RMS voltage is 50 V, triggering the trace memory feature for the settings above.
A centered one cycle undervoltage fault is shown below. In this case, the first cycle RMS voltage is 79.05 V
and the second cycle RMS voltage is 79.05 V, triggering the trace memory feature for the settings above.
A half cycle undervoltage fault is shown below. In this case, the first cycle RMS voltage is 70.07 V and the sec-
ond cycle RMS voltage is 100 V, triggering the trace memory feature for the settings above.
–200
–150
–100
–50
0
50
100
150
200
–200
–150
–100
–50
0
50
100
150
200
–200
–150
–100
–50
0
50
100
150
200