Endress+Hauser TopClean S CPC 30, Руководство по эксплуатации

Страница: 99 / 146

TopClean S CPC 30 8 Trouble-shooting
Hauser 99
E030 M
A
I
N
T
E
N
A
N
C
E
R
E
Q
U
I
R
E
D
SCS fault reference
electrode Reference impedance too high:
Check reference element and, if necessary replace
reference or combination electrode
For IsFET sensor: leak current > 400 nA.
yes no – –
E032 Outside set slope
range for sensor Sensor aged or defective;
Reference aged, defective or diaphragm blocked;
Buffer solutions too old or contaminated;
PML not in the buffer solutions yes no – –
E033 Outside set zero point
for sensor yes no – –
E034 Outside set offset
range for sensor yes no – –
E040 SCC / electrode status
of sensor bad Check sensor, replace if necessary; maybe clean, (glass
membrane blocked or run dry; diaphragm blocked). yes no –
E043 Buffer difference too
small Wrong buffer used;
Buffer entry incorrect; buffer self-recognition defective. yes no –
E044 Meas. value unstable PML missing; sensor too old; sensor sometimes dry;
cable or plug defective. yes no –
E045 Calibration aborted yes no –
E055 Display range of main
parameter 1 undershot
Measuring line broken,
sensor in air or air cushion in assembly,
Potential matching missing in symmetrical measurement,
static charging in media with lowest conductivity
yes no no
E057 Display range of main
parameter 1 exceeded yes no no
E059 Temperature range 1
undershot
Temperature sensor defective;
Sensor line interrupted or short-circuited;
Wrong sensor type selected
yes no no
E061 Temperature range 1
exceeded yes no no
E063 Current limit
0/4 mA output 1
Measured value outside specified current range:
Check measured value for plausibility,
if necessary adjust current output assignment 0/4 mA
and/or 20 mA.
yes no no
E064 Current limit 20 mA
output 1 yes no no
E065 Current limit 0/4 mA
output 2 yes no no
E066 Current limit 20 mA
output 2 yes no no
Error
No. N
A
M
U
R Error message Possible causes / measures Alarm
contact Error
current Automatic
cleaning
start
Fact. User Fact. User Fact. User