Endress+Hauser TopClean S CPC 30, Руководство по эксплуатации

Страница: 47 / 146

TopClean S CPC 30 6 Commissioning
Hauser 47
JC6 Off
On
SCC (Sensor Condition Check)
This function monitors the electrode status or the
degree of electrode ageing. Possible status messages:
"Electrode OK", "Low wear" or "Replace electrode". The
electrode status is updated after each calibration.
When the "Replace electrode" message appears, an
error message may be displayed (E040, E041)..
!
Note!
This function is only available for glass electrodes. If
you are using a glass electrode and an IsFET sensor,
you can use the SCC function without restriction.
However, the SCC function only monitors the glass
electrodes.
E1
JC7 Function:
Isoth.p.: off
000 mV/
pH00.00
(±500mV /
0...16pH)
Isothermic compensation
Here, you activate the isothermic compensation and
enter the isothermic intersection point.
Function off
: For E+ H electrodes.
Function on
: Required when the isotherms from the
electrode do not meet at pH 7.
Isothermic point
: Enter the intersection point at which
the isotherms of the electrode meet. For glass
electrodes you enter the value in mV, for IsFET sensors
as pH value.
!
Note!
When you activate the isothermic compensation the
electrode has to be calibrated before measuring.
E1
JC8 Threshold
Length 02 mV
010 s
Stability
During calibration, the mV value may change during
the given period ("duration") at maximum by the stated
amount ("threshold"), so that the calibration is
considered as stable.
Therefore you can adjust accuracy and timing
individually to your process.
E1
Calibration timer:
JD1 Cal timer:
Warning:
___________
Time:
on
0001h
0001:00
Calibration timer
If no calibration is undertaken in the set time, an error
message appears (E115).
Cal timer
: On = activate
Warning
: Enter the time within a calibration must take
place.
Time
: Display of the remaining time to an error
message (count down).
E2
CODE CHOICE
(default = bold) INFO
(E1, 2 = Editor types, s. page 28)
User
settings